Technical > General Support
Any way to store UEFI settings on an image?
(1/1)
tlscott99:
I have 100+ HP Touchscmart AIO systems to install Ubermix 3.1. These systems are set to UEFI by default in BIOS. I can image each system fine if I use the UM 3.1 USB directly on each machine, using UEFI settings. It boots fine under UEFI.
My question - is there a way to store the UEFI settings when I create a USB image from this particular computer. I like to pre-image my hard drives but the UEFI settings don't seem to store the UEFI settings on the UM 3.1 USB I created.
I know I can do each system one at a time, but it would sure help to pre-image the hard drives with a UEFI settings. Any suggestions?
Navigation
[0] Message Index
Go to full version